Editing Tucker 48 (section)

==== Pre-Selector manual transmission ====
It was discovered that the [[Cord 810/812]]'s Auburn Gear, front-wheel-drive; 4-speed transmission, with the Bendix "Electric Hand" electro-vacuum shifting mechanism, fit the immediate design requirements needed to get the cars built, and on the road; until a future automatic (Tucker-built transmission) was worked out. This transmission was designed originally behind a standard V-8 engine, and pointed forward towards the front of the car, for the front wheels. However, this transmission came with a poor reputation, following its original use, in the [[Cord 810]] automobile. (In 1936, when the Cord 810 made its debut at the New York Automobile show, the transmissions were so problematic that 810 models were mostly shown without any transmission installed. Problems abounded until the last Cord was produced in 1937.) The Cord transmissions, even with refurbishing, were initially inadequate for the power and torque of the O-335 engine. The Cords lacked adequate lubrication and the main shaft was so long that it warped under load (causing gears to pop out of play), and the gear-teeth were quite weak. Nevertheless, in the Tucker, this transmission worked well enough for the new engine configuration; it provided an adequate (albeit fragile) transmission, with a reverse gear. The company then sent several of its staff, including Preston Tucker Jr., on a campaign to buy used Cord transmissions, for reconditioning; a total of 22 used transmissions were acquired from junkyards and used car dealers. These transmissions were taken to the Ypsilanti Machine And Tool Company. After refurbishment, several were mated to the O-335 and found to work, providing four speeds forward and reverse. It was decided, consequently, that the Cord design – nearly 12 years old – would become the "manual transmission" for the 1948 and subsequent Tucker automobiles. About 18 of the 22 Cords were found to be usable and – since newly made Y-1 transmissions were not yet available – were installed in production Tucker vehicles. Several of the cars have survived with Cord transmissions.