Editing Plotter (section)

====Static cutting table====
A static cutting table is a type of cutting plotter used a large flat [[vacuum table]]. It is used for cutting non-rigid and porous material such as textiles, foam, or leather, that may be too difficult or impossible to cut with roll-fed plotters. Static cutters can also cut much thicker and heavier materials than a typical roll-fed or sheet-fed plotter is capable of handling.

The surface of the table has a series of small pinholes drilled in it. Material is placed on the table, and a coversheet of plastic or paper is overlaid onto the material to be cut. A vacuum pump is turned on, and air pressure pushes down on the coversheet to hold the material in place. The table then operates like a normal vector plotter, using various cutting tools to cut holes or slits into the fabric. The coversheet is also cut, which may lead to a slight loss of vacuum around the edges of the coversheet, but this loss is not significant.