Editing Group delay and phase delay (section)

==== Amplitude Modulation ====
[[Amplitude modulation]] creates the passband signal by shifting the baseband frequency components to a much higher frequency range.  Although the frequencies are different, the passband signal carries the same information as the baseband signal. The demodulator does the inverse, shifting the passband frequencies back down to the original baseband frequency range. Ideally, the output (baseband) signal is a time delayed version of the input (baseband) signal where the waveform shape of the output is identical to that of the input.

In Figure 1, the outer system phase delay is the meaningful performance metric. ''For amplitude modulation, the inner red LTI device group delay becomes the outer LTI device phase delay''. If the inner red device group delay is completely flat in the frequency range of interest, the outer device will have the ideal of a phase delay that is also completely flat, where the contribution of distortion due to the outer LTI device's phase response&mdash;determined entirely by the inner device's possibly different phase response&mdash;is eliminated. In that case, the group delay of the inner red device and the phase delay of the outer device give the same time delay figure for the signal as a whole, from the baseband input to the baseband output. It is significant to note that it is possible for the inner (red) device to have a very non-flat phase delay (but flat group delay), while the outer device has the ideal of a perfectly flat phase delay.  This is fortunate because in LTI device design, a flat group delay is easier to achieve than a flat phase delay.