Editing Harmonica (section)

===Reed plate===
The reed plate is a grouping of several reeds in a single housing. The reeds are usually made of brass, but steel, aluminium, and plastic are occasionally used. Individual reeds are usually riveted to the reed plate, but they may also be welded or screwed in place. Reeds fixed on the inner side of the reed plate (within the comb's air chamber) respond to blowing, while those fixed on the outer side respond to suction.

Most harmonicas are constructed with the reed plates screwed or bolted to the comb or each other. A few brands still use the traditional method of nailing the reed plates to the comb. Some experimental and rare harmonicas also have had the reed plates held in place by tension, such as the WWII-era all-American models. If the plates are bolted to the comb, the reed plates can be replaced individually. This is useful because the reeds eventually go out of tune through normal use, and certain notes of the scale can fail more quickly than others.

A notable exception to the traditional reed plate design is the all-plastic harmonicas designed by Finn Magnus in the 1950s, in which the reed and reed plate were molded out of a single piece of plastic. The Magnus design had the reeds, reed plates, and comb made of plastic and either molded or permanently glued together.