Editing Optical amplifier (section)

== Raman amplifier ==
{{Main|Raman amplification}}
In a Raman amplifier, the signal is intensified by [[Raman amplification]]. Unlike the EDFA and SOA the amplification effect is achieved by a nonlinear interaction between the signal and a pump laser within an optical fiber. There are two types of Raman amplifier: distributed and lumped. A distributed Raman amplifier is one in which the transmission fiber is utilised as the gain medium by multiplexing a pump wavelength with signal wavelength, while a lumped Raman amplifier utilises a dedicated, shorter length of fiber to provide amplification. In the case of a lumped Raman amplifier, a highly nonlinear fiber with a small core is utilised to increase the interaction between signal and pump wavelengths, and thereby reduce the length of fiber required.

The pump light may be coupled into the transmission fiber in the same direction as the signal (co-directional pumping), in the opposite direction (contra-directional pumping) or both. Contra-directional pumping is more common as the transfer of noise from the pump to the signal is reduced.

The pump power required for Raman amplification is higher than that required by the EDFA, with in excess of 500&nbsp;mW being required to achieve useful levels of gain in a distributed amplifier. Lumped amplifiers, where the pump light can be safely contained to avoid safety implications of high optical powers, may use over 1 W of optical power.

The principal advantage of Raman amplification is its ability to provide distributed amplification within the transmission fiber, thereby increasing the length of spans between amplifier and [[Signal regeneration|regeneration]] sites. The amplification bandwidth of Raman amplifiers is defined by the pump wavelengths utilised and so amplification can be provided over wider, and different, regions than may be possible with other amplifier types which rely on dopants and device design to define the amplification 'window'.

Raman amplifiers have some fundamental advantages. First, Raman gain exists in every fiber, which provides a cost-effective means of upgrading from the terminal ends. Second, the gain is nonresonant, which means that gain is available over the entire transparency region of the fiber ranging from approximately 0.3 to 2&nbsp;μm. A third advantage of Raman amplifiers is that the gain spectrum can be tailored by adjusting the pump wavelengths. For instance, multiple pump lines can be used to increase the optical bandwidth, and the pump distribution determines the gain flatness. Another advantage of Raman amplification is that it is a relatively broad-band amplifier with a bandwidth > 5 THz, and the gain is reasonably flat over a wide wavelength range.<ref name="Optical Amplifier Tutorial">{{cite web|url=http://www.fiberstore.com/Optical-Amplifier-Tutorial-aid-359.html|title=Optical Amplifier Tutorial - FS.COM|first=FiberStore|last=Team|website=Fiberstore.com|access-date=10 August 2017}}</ref>

However, a number of challenges for Raman amplifiers prevented their earlier adoption. First, compared to the EDFAs, Raman amplifiers have relatively poor pumping efficiency at lower signal powers. Although a disadvantage, this lack of pump efficiency also makes gain clamping easier in Raman amplifiers. Second, Raman amplifiers require a longer gain fiber. However, this disadvantage can be mitigated by combining gain and the dispersion compensation in a single fiber. A third disadvantage of Raman amplifiers is a fast response time, which gives rise to new sources of noise, as further discussed below. Finally, there are concerns of nonlinear penalty in the amplifier for the WDM signal channels.<ref name="Optical Amplifier Tutorial"/>

''Note: The text of an earlier version of this article was taken from the public domain [[Federal Standard 1037C]].''