Editing Electromagnet (section)

===Inductive voltage spikes===
An electromagnet has significant [[inductance]], and resists changes in the current through its windings. Any sudden changes in the winding current cause large voltage spikes across the windings. This is because when the current through the magnet is increased, such as when it is turned on, energy from the circuit must be stored in the magnetic field. When it is turned off, the energy in the field is returned to the circuit.

If an ordinary [[switch]] is used to control the winding current, this can cause sparks at the terminals of the switch. This does not occur when the magnet is switched on, because the limited supply voltage causes the current through the magnet and the field energy to increase slowly. But when it is switched off, the energy in the magnetic field is suddenly returned to the circuit, causing a large voltage spike and an [[Electric arc|arc]] across the switch contacts, which can damage them. With small electromagnets, a [[capacitor]] is sometimes used across the contacts, which reduces arcing by temporarily storing the current. More often, a [[diode]] is used to prevent voltage spikes by providing a path for the current to recirculate through the winding until the energy is dissipated as heat. The diode is connected across the winding, oriented so it is reverse-biased during steady state operation and does not conduct. When the supply voltage is removed, the voltage spike forward-biases the diode and the reactive current continues to flow through the winding, through the diode, and back into the winding. A diode used in this way is called a [[freewheeling diode]] or [[flyback diode]].

Large electromagnets are usually powered by variable current electronic [[power supply|power supplies]], controlled by a [[microprocessor]], which prevent voltage spikes by accomplishing current changes slowly, in gentle ramps. It may take several minutes to energize or deenergize a large magnet.