Editing Network throughput (section)

==Goodput and overhead==
{{main|Goodput}}

The maximum throughput is often an unreliable measurement of perceived bandwidth, for example the file transmission data rate in bits per seconds. As pointed out above, the achieved throughput is often lower than the maximum throughput. Also, the protocol overhead affects the perceived bandwidth. The throughput is not a well-defined metric when it comes to how to deal with protocol overhead. It is typically measured at a reference point below the network layer and above the physical layer. The simplest definition is the number of bits per second that are physically delivered. A typical example where this definition is practiced is an Ethernet network. In this case, the maximum throughput is the [[gross bit rate]] or raw bit rate.

However, in schemes that include [[forward error correction codes]] (channel coding), the redundant error code is normally excluded from the throughput. An example in [[modem]] communication, where the throughput typically is measured in the interface between the [[Point-to-Point Protocol]] (PPP) and the circuit-switched modem connection. In this case, the maximum throughput is often called [[net bit rate]] or useful bit rate.

To determine the actual data rate of a network or connection, the "[[goodput]]" measurement definition may be used. For example, in file transmission, the "goodput" corresponds to the file size (in bits) divided by the file transmission time. The "[[goodput]]" is the amount of useful information that is delivered per second to the [[application layer]] protocol. Dropped packets or packet retransmissions, as well as protocol overhead, are excluded. Because of that, the "goodput" is lower than the throughput. Technical factors that affect the difference are presented in the "[[goodput]]" article.