Editing Tablet (pharmacy) (section)

===Wet granulation===
Wet granulation is a process of using a liquid binder to lightly agglomerate the powder mixture.  The amount of liquid has to be properly controlled, as over-wetting will cause the granules to be too hard and under-wetting will cause them to be too soft and friable. Aqueous solutions have the advantage of being safer to deal with than solvent-based systems but may not be suitable for drugs which are degraded by hydrolysis.

; Procedure
# The active ingredient and excipients are weighed and mixed.
# The wet granulate is prepared by adding the liquid binder–adhesive to the powder blend and mixing thoroughly. Examples of binders/adhesives include aqueous preparations of cornstarch, natural gums such as acacia, cellulose derivatives such as methyl cellulose, [[gelatin]], and povidone.
# Screening the damp mass through a mesh to form pellets or granules.
# Drying the granulation.  A conventional tray-dryer or fluid-bed dryer are most commonly used.
# After the granules are dried, they are passed through a screen of smaller size than the one used for the wet mass to create granules of uniform size.

Low shear wet granulation processes use very simple mixing equipment, and can take a considerable time to achieve a uniformly mixed state.  High shear wet granulation processes use equipment that mixes the powder and liquid at a very fast rate, and thus speeds up the manufacturing process. Fluid bed granulation is a multiple-step wet granulation process performed in the same vessel to pre-heat, granulate, and dry the powders.  It is used because it allows close control of the granulation process.