Editing Router (woodworking) (section)

== Table mounted router ==
[[File:Router table showing router attached.jpg|thumb|right|View underneath a router table showing plunge router attached.]]
A router may be mounted upside down in a [[Router table (woodworking)|router table]] or bench. The router's base plate is mounted to the underside of the table, with a hole allowing the bit to protrude above the table top. This allows the work to be passed over the router, rather than passing the router over the work. This has benefits when working with smaller objects and makes some router operations safer to execute. A router table may be fitted with a [[Fence (woodworking)|fence]], fingerboards and other work-guiding accessories to make the operation safer and more accurate.

A simple router table consists of a rigid top with the router bolted or screwed directly to the underside. More complex solutions can be developed to allow the router to be easily removed from the table as well as facilitate adjusting the router's bit height using a ''lift'' mechanism; there is a wide range of commercially available systems.

In this mode, the router can perform tasks similar to a [[wood shaper|spindle moulder]]. For smaller, lighter jobs, the router used in this way can be more convenient than the spindle moulder, with the task of set up being somewhat faster. There is also a much wider range of bit profiles available for the router, although the size is limited.

The router table is usually oriented so that the router bit is vertical and the table over which the work is passed is horizontal. Variations on this include the horizontal router table, in which the table remains horizontal but the router is mounted vertically above the table, so that the router bit cuts from the side.  This alternative is for edge operations, such as panel raising and slot cutting.