Editing Forging (section)

===Upset forging===
{{redirect|Upsetting||upset (disambiguation)}}
Upset forging increases the diameter of the workpiece by compressing its length.<ref name="Degarmo395"/> Based on number of pieces produced, this is the most widely used forging process.<ref name="Degarmo395"/> A few examples of common parts produced using the upset forging process are engine valves, couplings, bolts, screws, and other fasteners.

Upset forging is usually done in special high-speed machines called ''crank presses''. The machines are usually set up to work in the horizontal plane, to facilitate the quick exchange of workpieces from one station to the next, but upsetting can also be done in a vertical crank press or a hydraulic press. The initial workpiece is usually wire or rod, but some machines can accept bars up to {{convert|25|cm|in|abbr=on}} in diameter and a capacity of over 1000 tons. The standard upsetting machine employs split dies that contain multiple cavities. The dies open enough to allow the workpiece to move from one cavity to the next; the dies then close and the heading tool, or ram, then moves longitudinally against the bar, upsetting it into the cavity. If all of the cavities are utilized on every cycle, then a finished part will be produced with every cycle, which makes this process advantageous for mass production.<ref name="Degarmo395"/>

These rules must be followed when designing parts to be upset forged:<ref>Degarmo, pp. 395–396</ref>
*The length of unsupported metal that can be upset in one blow without injurious buckling should be limited to three times the diameter of the bar.
*Lengths of stock greater than three times the diameter may be upset successfully, provided that the diameter of the upset is not more than 1.5 times the diameter of the stock.
*In an upset requiring stock length greater than three times the diameter of the stock, and where the diameter of the cavity is not more than 1.5 times the diameter of the stock, the length of unsupported metal beyond the face of the die must not exceed the diameter of the bar.