Editing Ford Model T (section)

===Body===
<gallery mode="packed" heights="160px">
File:1910Ford-T.jpg|1910 Model T, photographed in Salt Lake City
File:Ford_T_1917.jpg|1917 Model T
File:1915 Ford Model T (01).jpg|1915 Model T Speedster
File:1925.ford.model.t.arp.750pix.jpg|1925 Ford "New Model" T Tudor sedan
</gallery>
Although Ford classified the Model&nbsp;T with a single letter designation throughout its entire life and made no distinction by model years, enough significant changes to the body were made over the production life that the car may be classified into several style generations.  The most immediately visible and identifiable changes were in the hood and cowl areas, although many other modifications were made to the vehicle.
* 1909–1914 – Characterized by a nearly straight, five-sided hood, with a flat top containing a center hinge and two side sloping sections containing the folding hinges. The firewall is flat from the windshield down with no distinct cowl. For these years, [[Carbide lamp|acetylene gas flame headlights]] were used because the flame is resistant to wind and rain. Thick concave mirrors combined with magnifying lenses projected the acetylene flame light. The [[fuel tank]] is placed under the front seat.
* 1915–1916 – The hood design is nearly the same five-sided design with the only obvious change being the addition of louvers to the vertical sides.  A significant change to the cowl area occurred with the windshield relocated significantly behind the firewall and joined with a compound-contoured cowl panel. In these years electric headlights replaced [[Carbide lamp|carbide]] headlights.
* 1917–1923 – The hood design was changed to a tapered design with a curved top. The folding hinges were now located at the joint between the flat sides and the curved top. This is sometimes referred to as the "low hood" to distinguish it from the later hoods. The back edge of the hood now met the front edge of the cowl panel so that no part of the flat firewall was visible outside of the hood.  This design was used the longest and during the highest production years, accounting for about half of the total number of Model&nbsp;Ts built.
* 1923–1925 – This change was made during the 1923 calendar year, so models built earlier in the year have the older design, while later vehicles have the newer design.  The taper of the hood was increased and the rear section at the firewall is about an inch taller and several inches wider than the previous design.  While this is a relatively minor change, the parts between the third and fourth generations are not interchangeable.
* 1926–1927 – This design change made the greatest difference in the appearance of the car.  The hood was again enlarged, with the cowl panel no longer a compound curve and blended much more with the line of the hood.  The distance between the firewall and the windshield was also increased significantly.  This style is sometimes referred to as the "high hood".

The styling on the last "generation" was a preview for the following Model A, but the two models are visually quite different, as the body on the A is much wider and has curved doors as opposed to the flat doors on the T.